Introduction

257
Crop
Application Rate (per acre) and Timing
Spring Application
Pre-harvest Application
Heat WG rate 10.4 g up to 28.4g up to 28.4g
Winter wheat PB PB 1
PB = May be planted back in the same season
1 = May only be planted the season following application
2 = May only be planted the second season following application
• Aerial Application: May be applied by aircraft for desiccation use only. DO NOT apply by air for any other use.
• Storage: Store in dry, cool storage. May be frozen.
• Buffer Zones:
Application method Crop Buffer Zones (metres † )
Required for the Protection of Terrestrial Habitat
Ground only* Lentil, Soybean 3
All other crops 10
Fixed wing airplane All desiccation uses 175
Helicopter All desiccation uses 150
See page 35 for an explanation of the different habitats.
* Buffer zones can be reduced by 70% when using shrouds and by 30% when using cones mounted less than
12 inches from the crop canopy.
†
Distance measured as metres from the downwind edge of the spray boom to sensitive habitat.
º DO NOT apply in areas where surface water from the treated area can run off to adjacent cropland, streams
Weed Control
Sprayer Cleaning:
Heat can cause injury to sensitive crops at very low concentrations. Sprayers used to apply this product should be flushed
out immediately after each day of use.
Refer to ‘Method B’ in the general section on sprayer cleaning on page 9 and 10.
Hazard Rating:
Caution – Possible Skin Irritant
For an explanation of the symbols used here see page 4.
Hotshot
Company:
ADAMA Canada
Herbicide Group
#6 – bromoxynil
#2 – florasulam
(Refer to page 44)
Formulation:
The (Hotshot) package contains two components:
Bromotril II (PCP#30371): 235 g/L bromoxynil formulated as an emulsifiable concentrate.
• Container size – 2 x 9.7 L
Priority (PCP#30831): 50 g/L florasulam formulated as a suspension concentrate.
• Container size – 1.6 L