Introduction

342
Weeds, Rates and Staging:
Unless otherwise indicated apply when weeds are at the 2 to 3 leaf stage and rosettes are less than 2 inches (5 cm) across.
At 246 mL per acre (80 acre per case) Pulsar controls:
º Cleavers
º Kochia (up to 9-leaf) º Wild buckwheat*
At 371 mL per acre (53 acre per case) Pulsar controls the weeds above plus:
º Lamb’s-quarters*
º Redroot pigweed*
º Russian thistle
º Stork’s-bill*
º Volunteer flax º Wild buckwheat
(up to 9-leaf)
* Suppression only
Application Information:
• Water Volume: Minimum 44.5 L per acre.
• Nozzles and Pressure: Use a maximum pressure between 40 and 45 PSI (275 to 310 kPa) for conventional flat fan
nozzles . Low drift nozzles may require higher pressures for proper performance. Use a combination of nozzles and
pressure designed to deliver thorough, even coverage with ASABE medium droplets.
How it Works:
Refer to Table 9 on page 48.
Effects of Growing Conditions:
DO NOT apply to crops that are stressed (frost, low fertility, drought or flooding, disease or insect damage) as crop injury or
reduced weed control may result.
Tank Mixes:
Herbicides:
• Barley, Spring wheat, and durum only:
º MCPA LV600 ester (0.23 L/acre)
• Spring wheat, and durum:
º Horizon NG (376 mL per acre)
º Horizon NG (376 mL per acre) plus MCPA LV600 ester (0.23 L per acre)
º Traxos (label rate)
º Traxos (label rate) + MCPA Ester (rates above)
Fertilizers: None registered
Note: The above mixes are those listed on the Pulsar label only.
Syngenta also supports the following mixes that are not on the Pulsar label. Apply mixes according to the most
restrictive use limitations for either product:
• Herbicides: 2,4-D Ester, 2,4-D Ester + Sierra 2.0, Express SG, Refine SG, Sierra 2.0.
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall: Within 1 hour may reduce control.
• Re-entry Interval: DO NOT enter treated fields for at least 12 hours.
• Pre-harvest Interval: Leave 60 days between treatment and harvest.
• Grazing Restrictions: Treated crops may be grazed, or cut for hay or silage after 7 days when used alone, or a
minimum of 12 days when mixed or longer if the intervals are longer for the tank mix partner.
• Re-cropping Interval: Wheat, barley, oats, rye, forage grasses, flax, canola, mustard, lentils and peas may be grown the
following season. There are no re-cropping restrictions the second year after application.
• Aerial Application: DO NOT apply by air.
• Storage: May be frozen. If frozen, bring to room temperature and agitate before use. This product is combustible.
DO NOT store near heat or open flame.