Introduction

389
Tank Mix Partner
Spring
wheat
Durum
Winter
wheat
Crops
Barley
Spring
rye
Lontrel (0.11 L per acre) + MCPA ester
• • •
(0.38 L per acre - 600 g/L forms)
MCPA ester† (0.38 L per acre - 600 g/L forms) • • • • • •
Prestige XC ††† • • • †† •
Fall rye
Triticale
†
Manufacturers may support different brands of generic products with their product. Check the tralkoxydim product
label for specific brands registered.
††
Liquid Achieve only.
†††
Liquid Achieve and Marengo only.
* Tank mixes may result in some temporary initial injury under adverse environmental conditions.
** Temporary crop injury can occur if applied prior to the 4 leaf stage. A reduction in wild oat control may occur with
this mix.
*** Buctril M mixed with either Liquid Achieve or Marengo only in winter wheat, fall rye and triticale.
DO NOT tank mix tralkoxydim products with herbicides or formulations of herbicides not listed above as loss of grass
control may result.
When applying broadleaf herbicides not listed above, in the same field, always apply tralkoxydim first. Apply the broadleaf
product no sooner than seven days after application of tralkoxydim.
Insecticides:
• Matador (49 mL per acre)
• Matador tank mixes with Bison may also be combined with bromoxynil or bromoxynil/MCPA ester products.
Fungicides: None registered.
Fertilizers: None registered.
Note: The above mixes are those listed on the tralkoxydim labels only.
Various manufacturers may also support additional mixes that are not on the tralkoxydim labels. Check with
manufacturers for more details.
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Weed Control
Restrictions:
• Rainfall: Within 1 hour will reduce control.
• Re-entry Interval: DO NOT enter treated field for 12 hours.
• Grazing Restrictions: Straw from treated grain crops may be fed to livestock. Immature cereal crops may be grazed or
cut for hay 16 days after treatment. DO NOT feed or graze forage crops in year of treatment
• Pre-harvest Interval: Leave 60 days from application to harvest.
• Re-cropping Interval: DO NOT replant treated areas to tame oat or corn for at least 4 weeks after application.
• Aerial Application: May be applied by air to cereal crops only. DO NOT apply within 50 m of fish bearing waters and
wildlife habitat.
• Storage: Store in a dry place. DO NOT freeze.
• Buffer Zones:
Application method
Buffer Zones (metres † ) Required for the Protection of:
Terrestrial habitat
Ground* 3
Helicopter 80
Fixed wing aircraft 100
See page 35 for an explanation of the different habitats.
* Buffer zones can be reduced by 70% when using shrouds and by 30% when using cones mounted less than
12 inches from the crop canopy.
†
Distance measured as metres from the downwind edge of the spray boom to sensitive habitat.