Simulator 16 User Guide - PowerWorld

Available Contingency Actions
The current edition of Simulator can process lists of contingencies including the following:
For Transmission Lines and Transformers (Branches)
The opening or closing of transmission lines and transformers
Opening all breakers to isolate and open a line or transformer
For individual Generators, Loads, or Switched Shunts
Loss or recovery of a particular generator, load, or switched shunt
Opening all breakers to isolate and open a particular generator, load, or switched shunt
For all the Generation, Load, or Switched Shunt at a particular bus
Movement of generation, load, or switched shunt MWs or Mvars to another terminal bus
Changing or setting of load, switched shunt, or generator MWs or Mvars
Change or setting of a generator or switched shunt voltage setpoint
Opening all breakers to isolate and open a particular generator, load or switched shunt
For Buses
Opening of all lines connected to a bus
For Interfaces
Opening or closing of all lines or transformers in an interface
Opening all breakers to isolate and open all lines or transformers in an interface
For Injection Groups
Opening, closing, or changing of output of all devices in an injection group
Setting or Changing the net MW Injection by a Percent or MW value and by proportion or by merit
order
Opening all breakers to isolate and open all devices in an injection group
Series Capacitors
Bypassing or placing series capacitors in service
Setting of the Series Reactance by percent or to a particular per unit value
Phase-Shifting Transformers
Changing or setting the Phase-Shifter Regulation MW value
DC Transmission Lines
Opening or closing DC Lines
Changing DC Line setpoint MW or Amp values
©2011 PowerWorld Corporation
1009