Simulator 16 User Guide - PowerWorld

as close to the desired amount without exceeding the desired amount of drop. If a
generator would cause the desired gen drop amount to be exceeded, that generator is
skipped and the next generator in merit order is processed. If the change requested is
positive, then generators will be increased toward their maximum MW output in the
same manner as though this option were not chosen.
Note: the [name] may be replaced by the label of the injection group.
Execute a Power Flow Solution
SOLVEPOWERFLOW
Include this action to cause the solution of the contingency to be split into pieces.
Actions that are listed before each SOLVEPOWERFLOW call will be performed as a group.
Make-Up Power Compensation.
Only valid immediately following a SET, CHANGE, OPEN or CLOSE action on a Generator,
Shunt or Load. This describes how the change in MW or MVAR are picked up by buses
throughout the system. The values specify participation factors
COMPENSATION
bus#1 value1
bus#2 value2
...
Example:
END
// just some comments
// action Model Criteria Status comment
"BRANCH
40821 40869 1
OPEN"
"GEN 45041 1
OPEN"
"BRANCH
42702 42727 1
OPEN"
"GEN 40221 1
OPEN"
"GEN 40227 1
OPEN"
"GEN 40221 1
OPEN"
"GEN 40227 1
OPEN"
©2011 PowerWorld Corporation
"" ALWAYS //Raver - Paul
500 kV
"" ALWAYS //Trip Unit #2
"Line X Limited" CHECK //Open Fern
Hill
"Interface L1" CHECK //Drop ~600
MW
"Interface L2" CHECK //Drop ~1200
MW
"Interface L3" CHECK //Drop ~600
MW
"Interface L3+" CHECK //Drop ~1200
MW
Note: ContingencyElement object types can also be created inside their own DATA section as well.
One of the key fields of the object is then the name of the contingency to which the
ContingencyElement belongs.
564