Simulator 16 User Guide - PowerWorld

ShowComplex : (optional) show complex form (MW+jMvar) (default=NO)
AutoInsertSubStations(LocationSource, MapProjection, AutoInsertBranches,
InsertIfNotAlreadyShown, “filename”, FileCoordinates);
Use this action to automatically insert substations based on specified location data.
LocationSource : “Bus”, “Substation” or “File”
MapProjection : “Simple Conic”, “Mercator” or “x,y”
AutoInsertBranches : YES to insert transmission lines when finished, NO not to
InsertOnlyIfNotAlreadyShown : YES if only buses that are not already shown should be
inserted, NO to insert all buses.
“filename” : (optional) path to location source file (if LocationSource is “File”)
FileCoordinates : (optional) format of coordinates in file “x,y” or “lon,lat” (if LocationSource is
“File”)
AutoInsertLineFlowPieCharts(MinkV, InsertOnlyIfNotAlreadyShown, InsertMSLines, Size);
Use this action to automatically insert line flow pie charts.
MinkV : Minimum kV level to insert (default=0)
InsertOnlyIfNotAlreadyShown: (optional) if existing line flow objects are ignored
(default=YES)
InsertMSLines : (optional) insert pie charts for Multi-Section Lines (default=YES)
Size : (optional) size (default=5.0)
AutoInsertInterfaces(InsertPieCharts, PieChartSize)
Use this action to automatically insert line flow objects.
InsertPieCharts : (optional) Insert pie charts as well (default=YES)
PieChartSize : (optional) default size of interface pie charts (default=50.0)
ResetStubLocations(ZBRImpedance, NoStubsZBRs)
Use this action to reset stub locations.
ZBRImpedance : (optional) max P.U. impedance for bus ties (default=0.0001)
NoStubsZBRs : (optional) Ignore stubs for bus ties (default=YES)
General Script Commands
The following script commands defined in the general Script section are available for display auxiliary
files as well:
ExitProgram
LoadScript
LoadData
SelectAll
UnSelectAll
©2011 PowerWorld Corporation
625