Simulator 16 User Guide - PowerWorld

QV Curves Results: Listing
The Listing sub-tab is found on the Results page of the QV Curves dialog. This page provides a
summary of all scenarios studied and their results. This table will update as the analysis progresses.
The listing is a case information display and therefore can be used in a manner consistent with all
other case information displays.
There are a number of fields that are shown by default on the display:
Number, Name, Nom kV
Number, name, and nominal kV voltage of the studied bus, respectively. This along with the Case
Name identifies the scenario.
Case Name
Either BASECASE or the name of a contingency. This along with the Number, Name, and Nom kV
identifies the scenario.
V at Q0
Q0
Per-unit voltage in the starting case (base case operating point). The starting case is either the base
case or a contingency case. This is the voltage that is recorded prior to starting any QV curve
tracing. This is the voltage at Q0.
If the case is not solvable and a successful attempt is made at finding the solvable point by using
the fake generator to provide Mvar injection, this is the voltage recorded once the case becomes
solvable.
Mvar output of the fake generator in the starting case (base case operating point). The starting case
is either the base case or contingency case. This is the Mvar output that is recorded prior to starting
any QV curve tracing.
If the case is not solvable and a successful attempt is made at finding the solvable point by using
the fake generator to provide Mvar injection, this is the Mvar output of the fake generator that is
©2011 PowerWorld Corporation
1240