3. - Fagor Automation

Operating manual
5.
JOG
CNC 8035
·T· MODEL
(SOFT V16.3X)
·100·
When must a home search be done
The CNC demands a home search in the following cases.
On CNC power-up.
After executing the sequence [SHIFT] [RESET].
When the feedback is direct through the axes board and a feedback alarm occurs.
When modifying certain machine parameters; for example, number of axes.
"PRESET" softkey
With this function it is possible to preset the desired axis position value. Once this option is selected,
the CNC will show the softkey corresponding to each axis.
After pressing the softkey of the corresponding axis to be preset, the CNC will request the position
value to be preset with.
Press [ENTER] after the value has been keyed in so the new value is assumed by the CNC.
"TOOL CALIBRATION" softkey
With this function it is possible to calibrate the length of the selected tool by using a part of known
dimensions for this purpose.
Before pressing this softkey, the tool to be calibrated must be selected.
The tool calibration is performed axis by axis (X, Z). Follow these steps:
1. Press the softkey corresponding to the axis [X] or [Z].
2. The CNC will request the position value of the known part at the touch point. Once this value
has been keyed in, press [ENTER] for this value to be assumed by the CNC.
3. Move the tool using the JOG keys until touching the part.
4. Press the "LOAD" softkey for that axis.
The CNC will perform the necessary calculations and it will assign the new value to the selected
tool length offset.
Repeat these operation to calibrate the tool along the other axis.