3. - Fagor Automation

FIND
This option will be executed regardless of which is the active window and it offers the following
searching options:
BEGINNING
This softkey positions the cursor over the first program block which is then selected quitting the "find"
option.
END
This softkey positions the cursor over the last program line and quits the "find" option.
TEXT
With this function it is possible to search for a text or character sequence starting at the current cursor
position. When this softkey is pressed, the CNC requests the character sequence to be found.
The CNC will consider a text found when it is between blank spaces or separators. Thus, When
looking for "I1" it will not find or stop at "I12" or "I123", but only at "I1".
Once this text has been keyed in, press the "END OF TEXT" softkey and the cursor will position
over the first occurrence of the keyed text.
The search will begin from the block the cursor is position on beginning at that block.
The text found will be highlighted being possible to continue with the search or to quit it.
Press [ENTER] to continue the search up to the end of the program. The CNC will begin the search
at the last text found and it will highlight it.
The search can be done as many times as desired. Once searched to the end of the program, it
will continue the search from the beginning.
Press the "ABORT" softkey or the [ESC] key to quit the search mode.
Activate / deactivate symbols
With this option it is possible to display in all available windows the symbols or mnemonics
associated to the various resources.
The names of the resources may be displayed in two ways: using their generic names (I, O, M, T,
C , R) by deactivating symbols or using their associated symbols by activating them.
When a resource has no mnemonic associated to it, it will always be displayed with its generic name.
This softkey will toggle between ACTIVATE SYMBOL and DEACTIVATE SYMBOL every time is
pressed in order to show which option is available.
Logic analyzer
It is especially suited to help in the machine start-up and for troubleshooting errors and critical
situations in signal behavior.
It is described in full detail later in this chapter.
PLC start-up
When selecting this option, the CNC will start executing the PLC program from the beginning,
including the CY1 cycle.
The CNC does not execute this option when the PLC program is running.
Operating manual
PLC
Monitoring 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·165·