3. - Fagor Automation

Create window
This CNC allows the possibility of creating windows to display the status of the various PLC
resources. These windows will be shown overlapping the PLC program and the information
displayed in them will be updated dynamically.
The options "MODIFY WINDOW", "ACTIVE WINDOW" and "ACTIVATE SYMBOLS" allow the
manipulation of these windows.
Every time a new window is created, the CNC will assign 2 data lines to it in order to display the
status of the desired resources.
There are two types of windows which can be selected with softkeys.
Window to display timers and registers
This window is divided into two sections, one to display timers and the other one to display registers.
Timer.
It will show one timer per line showing the following information for each one of them:
TG Indicates the logic status of the active trigger input.
M Indicates the status of the timer: "S" means stopped, "T" means timing and "D"
means disabled.
TEN Indicates the logic status of the enable input.
TRS Indicates the logic status of the enable input.
T Indicates the logic status of the status output of the timer.
ET Indicates the elapsed time.
TO Indicates the remaining time.
Key in the command T 1/256 or T 1/256.1/256 to request the data on a timer or group of timers and
then press [ENTER].
Register.
It will display one register per line showing the following information fields for each of them:
HEX Indicates the hexadecimal value of its contents.
DEC Indicates the decimal value of its contents (with sign).
Key in R 1/559 or R 1/559.1/559 to request information on one or more registers and, then, press
[ENTER].
Window to display counters and binary data
This window is divided into two sections, one to display counters and the other one to display binary
data.
Counters.
It will display one counter per line showing the following information fields for each of them:
CEN Indicates the logic status of the enable input.
CUP Indicates the logic status of the UP COUNT input.
CDW Indicates the logic status of the DOWN COUNT input.
CPR Indicates the logic status of the preset input.
S Indicates the status of the counter. "1" when its internal count is 0 and 0 for all
other cases.
C Indicates its count value.
Key in C 1/256 or C 1/256.1/256 to request information on one or more counter and, then, press
[ENTER].
Operating manual
PLC
Monitoring 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·163·