3. - Fagor Automation
3. - Fagor Automation
3. - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating manual<br />
<strong>3.</strong><br />
EXECUTE / SIMULATE<br />
Graphics<br />
CNC 8035<br />
·T· MODEL<br />
(SOFT V16.3X)<br />
·76·<br />
<strong>3.</strong>5.3 Zoom<br />
In order to use this function, no part program may be in execution or simulation. If this is the case,<br />
it must be interrupted.<br />
With this option, it is possible to enlarge or reduce the graphics display area.<br />
When selecting this option, the CNC will show a window superimposed on the current graphics and<br />
another one over the drawing at the lower right-hand side of the screen. These new windows indicate<br />
the new display area being selected.<br />
Use the softkeys [zoom +], [zoom-] and the keys [+], [-] to either enlarge or reduce the size of the<br />
new display area and the [] [] [] [] keys to move the zoom window around to the desired<br />
location on the screen.<br />
The "initial value" softkey assumes the values set with this softkey "display area" The CNC shows<br />
that value, but does not quit the ZOOM function.<br />
Once the new display area has been defined, press [ENTER] to validate the new values.<br />
To quit this mode without making any changes, press [ESC].<br />
Every time a zoom is carried out, it redraws the machining executed up to that point. If the number<br />
of points to be redrawn exceeds the amount of memory reserved for it, only the last points will be<br />
redrawn and the older ones will be lost.
Change language