3. - Fagor Automation

Operating manual
9.
PLC
Logic analyzer
CNC 8035
·T· MODEL
(SOFT V16.3X)
·184·
Selection of the time base
The operator may use this parameter to assign the timeframe to each vertical division.
The size of these divisions, therefore the resolution of these signals will be determined by this time
base. Consequently, the smaller the time base, the greater the signal resolution.
Example:
There is a mark that changes states every 2 milliseconds.
Using a 10 millisecond time base, it will look like this:
Using a 20 millisecond time base, it will look like this:
Using a 4 millisecond time base, it will look like this:
The time base is defined in milliseconds and the selected value will be shown in the information
window. By default, the CNC assumes a time base of 10 milliseconds.
At first, a time base may be defined that will match the frequency of the signals to be treated. Then,
when analyzing the trace, that base time may be modified to obtain a higher resolution of the signals.