3. - Fagor Automation

3.1.2 Automatic block search
It may be used to restore the program history up to the block where the execution was interrupted.
The CNC remembers in which block the execution was interrupted, thus not being necessary to set
the stop block.
If the program is interrupted inside an internal cycle, it will behave as follows:
If it is a pocket cycle (G66, G67, G68, G87, G88) or a multiple cycle (G60, G61, G62, G63, G64),
when doing a home search, it restores the history up to the last subblock inside the completed
cycle.
In the rest of the canned cycles (G69, G81, G82, G84, G85, G86), it is interrupted inside the
cycle, it restores the history up to the cycle calling block.
To access the automatic block search, press and press one of the operating
modes or .
Then, press the and softkeys.
The softkey is only shown when the block that has been stored for the
automatic search is located among those of the program and once pressed places the cursor in that
block.
Once the block has been selected, the screen shows the text STOP=HD:PxxxLxxx that indicates
the location of the program, the program number and the program line. After pressing [CYCLE
START] the CNC searches the block and once simulated up to the stop block, it removes the previous
text.
Then, the CNC determines the axes that are out of position and shows them so they can be selected.
If it has also searched for G functions and the program contains M, S, T functions that must be
executed, the menu shows the softkey so those functions are executed
after pressing the softkey and validating it with [CYCLE START].
Tool inspection:
Pressing the accesses tool inspection.
Pressing the softkey displays the M, S and T functions that have been
simulated and are pending to be executed.
Pressing the softkey access that mode and lets the user execute the desired blocks.
Operating manual
EXECUTE / SIMULATE
Block search. Switching from simulation to execution 3.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·55·