3. - Fagor Automation
3. - Fagor Automation
3. - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating manual<br />
<strong>3.</strong><br />
EXECUTE / SIMULATE<br />
Tool inspection<br />
CNC 8035<br />
·T· MODEL<br />
(SOFT V16.3X)<br />
·70·<br />
<strong>3.</strong>4 Tool inspection<br />
This function is not available in the "program simulation" mode. Besides, if a program is being<br />
executed, it must be interrupted in order to access this function.<br />
This operating mode allows all the machine movements to be controlled manually, and enabling the<br />
axis control keys on the operator panel. Also, the CNC will show the softkeys to access the CNC<br />
tables, edit and execute a block in MDI as well as repositioning the axes of the machine to the position<br />
from where this function was called.<br />
One of the ways to make the tool change is as follows:<br />
1. Move the tool to the required tool change position.<br />
This move may be made by jogging the axes from the operator panel or in MDI.<br />
2. Gain access to CNC tables (tools. Tool offsets, etc.) in order to find another tool with the similar<br />
characteristics.<br />
<strong>3.</strong> Select, in MDI, the new tool as the active one.<br />
4. Make the tool change<br />
This operation will be performed depending on the type of tool changer used. It is possible to<br />
execute the tool change in MDI in this step.<br />
5. Return the axes to the position where the tool inspection began (REPOSITIONING).<br />
6. Continue executing the program, pressing the [START] key.<br />
If during tool inspection, the spindle is stopped, the CNC will restart it in the same turning direction<br />
(M3 or M4) while repositioning.<br />
The CNC offers the following options by means of softkeys:<br />
"MDI" softkey<br />
Allows to edit blocks in ISO or high level (except those associated with subroutines) providing<br />
information on the corresponding format by means of softkeys.<br />
Once a block has been edited and after pressing the [START] key, the CNC will execute<br />
this block without leaving this operating mode.<br />
"TABLES" softkey<br />
Allows access to any of the CNC tables associated with part programs (zero offsets, tool offsets,<br />
tools, tool magazine and parameters).<br />
Once the desired table has been selected, all editing commands will be available for its verification<br />
and modification.<br />
Press the [ESC] key to return to the previous menu (tool inspection).