3. - Fagor Automation
3. - Fagor Automation
3. - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating manual<br />
9.<br />
PLC<br />
Edit<br />
CNC 8035<br />
·T· MODEL<br />
(SOFT V16.3X)<br />
·158·<br />
TO THE END<br />
This option will find and replace the selected text throughout the whole program.<br />
This "find and replace" will start at the highlighted text and will go on to the end of the program.<br />
ABORT<br />
This option will not replace the highlighted text and it will quit the "find and replace" mode.<br />
"DELETE BLOCK" softkey<br />
With this function it is possible to delete a block or group of blocks.<br />
To delete only one block, just position the cursor over it and press [ENTER].<br />
To delete a group of blocks, indicate the first and last blocks to be deleted. To do that, proceed as<br />
follows:<br />
1. Position the cursor over the first block to be deleted and press the "INITIAL BLOCK" softkey.<br />
2. Position the cursor over the last block to be deleted and press the "FINAL BLOCK" softkey. If<br />
the last block to be deleted is also the last one of the program, it can also be selected by pressing<br />
the "TO THE END" softkey.<br />
Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting<br />
confirmation to delete them.<br />
"MOVE BLOCK" softkey<br />
With this option it is possible to move a block or group of blocks by previously indicating the first and<br />
last blocks to be moved. To do that, proceed as follows:<br />
1. Position the cursor over the first block to be moved and press the "INITIAL BLOCK" softkey.<br />
2. Position the cursor over the last block to be moved and press the "FINAL BLOCK" softkey. If the<br />
last block to be moved is also the last one of the program, it can also be selected by pressing<br />
the "TO THE END" softkey.<br />
To move only one block, the "initial block" and the "final block" will be the same one.<br />
Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting<br />
confirmation to move them.<br />
Then, indicate the block after which this group of blocks must be placed. Press the "START<br />
OPERATION" softkey to carry out this command.