3. - Fagor Automation
3. - Fagor Automation
3. - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
"COPY BLOCK" softkey<br />
With this option it is possible to copy a block or group of blocks by previously indicating the first and<br />
last blocks to be copied. To do that, proceed as follows:<br />
1. Position the cursor over the first block to be copied and press the "INITIAL BLOCK" softkey.<br />
2. Position the cursor over the last block to be copied and press the "FINAL BLOCK" softkey. If the<br />
last block to be copied is also the last one of the program, it can also be selected by pressing<br />
the "TO THE END" softkey.<br />
To copy only one block, the "initial block" and the "final block" will be the same one.<br />
Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting<br />
confirmation to copy them.<br />
Then, indicate the block after which this group of blocks must be placed. Press the "START<br />
OPERATION" softkey to carry out this command.<br />
"COPY TO PROGRAM" softkey<br />
With this option it is possible to copy a block or group of blocks of one program into another program.<br />
When selecting this option, the CNC will request the number of the destination program where the<br />
selected block or blocks are to be copied. After entering the program number press [ENTER].<br />
Next, indicate the first and last blocks to copy. To do that, proceed as follows:<br />
1. Position the cursor over the first block to be copied and press the "INITIAL BLOCK" softkey.<br />
2. Position the cursor over the last block to be copied and press the "FINAL BLOCK" softkey. If the<br />
last block to be copied is also the last one of the program, it can also be selected by pressing<br />
the "TO THE END" softkey.<br />
To copy only one block, the "initial block" and the "final block" will be the same one.<br />
Once the first and last blocks are selected, the CNC will highlight the selected blocks and will execute<br />
the command.<br />
If the destination program already exists, the following options will be displayed:<br />
Write over the existing program. All the blocks of the destination program will be erased and will<br />
be replaced by the copied blocks.<br />
Append (add) the copied blocks behind the ones existing at the destination program.<br />
Abort or cancel the command without copying the blocks.<br />
"INCLUDE PROGRAM" softkey<br />
With this option it is possible to include or merge the contents of another program into the one<br />
currently selected.<br />
Once this option is selected, the CNC will request the number of the source program to be merged.<br />
After entering the program number press [ENTER].<br />
Next, indicate with the cursor the block after which the source program will be included.<br />
Press the "START OPERATION" softkey to carry out this command.<br />
Operating manual<br />
PLC<br />
Edit 9.<br />
CNC 8035<br />
·T· MODEL<br />
(SOFT V16.3X)<br />
·159·