3. - Fagor Automation

Operating manual
6.
TABLES
Tool geometry table.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·126·
Cutter width (NOSEW).
Cutting angle (CUTA).
The parameters corresponding to the cutter angle (NOSEA) and the cutter width (NOSEW) must
always be defined.
When the cutter is square, its angle value will be 90o (NOSEA = 90).
When the cutter is round, the cutter angle will be 90o (NOSEA=90) and
the parameter corresponding to the cutter width must be assigned its
diameter value (NOSEW = 2R).
The cutting angle (CUTA) must only be defined when the selected tool type (location code "F") is
F1, F3, F5 or F7.
If the selected tool type is F0 or F9, it is not necessary to define any parameter and if it is F1, F3,
F5 or F7, the following parameters must be defined: the cutter angle (NOSEA), the cutter width
(NOSEW) and the cutting angle (CUTA).
When the selected tool type is F2, F4, F6 or F8, only the cutter angle (NOSEA) and width (NOSEW)
must be defined.
When using a drill bit or end-mill, Tool type (location code) F10 must be used being necessary to
define the values of of NOSEW (cutter width) and NOSEA (cutter tip angle).