3. - Fagor Automation

6.1 Zero offset table
This table stores the offset of each axis.
The end of the chapter describes how to edit the table. The possible zero offsets are:
PLC. Additive zero offset defined by PLC.
It is used, for example, to correct deviations originated by machine dilatations.
These values are set from the PLC and from the part-program, by means of high level variables
"PLCOF(X-C)".
The CNC always adds these values to the zero offset currently active.
G54 through G57. Absolute zero offsets.
They can also be modified from the PLC and from the part-program, by means of high level variables
"ORG(X-C)".
In order for one of these absolute zero offsets to be active, it must be selected at the CNC using
its corresponding G code (G54, G55, G56 or G57).
G58 and G59. Incremental zero offsets.
They can also be modified from the PLC and from the part-program, by means of high level variables
"ORG(X-C)".
In order for one of these incremental zero offsets to be active, it must be selected at the CNC using
its corresponding G code (G58 or G59).
The new incremental zero offset will be added to the absolute zero currently selected.
Operating manual
TABLES
Zero offset table 6.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·117·