3. - Fagor Automation

Modifying permissions:
It may be used to modify the OEM, hidden, executable and read-only permissions of programs
that are displayed at the time in the explorer. Thus, if it is an OEM program, it will request an
OEM password and if a program is assigned the attribute, its relevant icon immediately
appears on the list of the explorer. After modified, its date/time will change.
To change the permission of a program, first select it in the right panel and after pressing the
softkey >permissions< option, it shows the text box "new comment" where the new
comment may be written.
No permission of a program may be renamed in DNC 1/2/E.
Delete
It may be used to delete a previously selected program. Only a modifiable program may be
deleted.
To delete a program, first select it in the right panel and after pressing the softkey,
>[CLEAR]< option, it will disappear from the program listing displayed in the explorer.
Copy
It copies the selected program onto the clipboard. First select the program to be copied in the
right panel and press the softkey option. Then, select the destination
folder and press the option located under the same >Actions< softkey.
Cut/move
It copies the selected program onto the clipboard. First select the program to be cut/move in the
right panel and press the >Actions< softkey option. Then, select the destination folder
and press the option located under the same >Actions< softkey. Once the content
of the clipboard has been pasted, the files will be deleted from the source folder and moved to
the new destination.
These operations are carried out using the horizontal softkeys shown at the bottom of the screen
and can only be carried out on the programs being displayed on the screen.
Operations on sets
The user may select a set of programs that are located in the right panel of the screen. This selection
may be done either individually or by range or as a whole.
These types of selection may be carried out after pressing the softkey and any of the
options shown depending on the task to be carried out. The available options are:
All / Nothing [ * ]
From / To [ _ ]
Select [ + ]
Deselect [ - ]
Invert
After selecting the programs individually, by range or as a whole, it is possible to carry out on them
the operations mentioned earlier.
Some operations may not be applicable to certain programs of the selection. In those
cases, the user will be informed and will be allowed to either resume or cancel the
operation.
Handling the directories
When the cursor is located on the left panel, on the "hard disk" drive any of the following actions
may be carried out on any of them:
Create a subdirectory
Rename a subdirectory
Operating manual
UTILITIES
Accessing the programs using the explorer 7.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·145·