3. - Fagor Automation

Operating manual
9.
PLC
Logic analyzer
CNC 8035
·T· MODEL
(SOFT V16.3X)
·188·
The message window of the CNC will show the amount of time between them. This time is given
in milliseconds.
This feature may be very useful to calculate precisely flank times of a signal, time between the trigger
of two signals, time between the trigger of a signal and the beginning of the cycle, etc.
Modify base
With this option it is possible to modify the "time base".
The status area is divided into several vertical stripes. Each stripe represents the amount of time
defined by the "time base" constant.
The "time base" is inversely proportional to the resolution of the signals; thus, the lower the "time
base" the greater the signal resolution and vice versa.
Pressing this softkey, the CNC will request the new value to be assigned to the time base. This value
is given in milliseconds.