4 - Fagor Automation

4.
CANNED CYCLES OF THE EDITOR
Thread milling.
CNC 8065
(REF: 1209)
·110·
4.7 Thread milling.
Inside thread milling: outside thread milling:
B
K
Geometric parameters:
Type of tapping.
Machining direction.
Thread machining direction.
Type of tapping.
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
Canned cycles (·M· model)
Defines the type of threading to be carried out (inside or outside).
Defines the direction of the helical drilling path.
It defines the thread cutting direction (from the part surface down to the bottom
of the thread or from the bottom up to the part surface).
It depends on the type of tool being used.
Dp Part surface approach distance.
The editor will only show this data if the user has configured the editor to allow it. If this option
is not enabled, the cycle assumes an approach distance of 1 mm.
φ Thread diameter.
K Thread depth.
B Thread pitch.
Ds Approach distance.
δ
Δ
φ
Zs
P
α Thread entry (start) angle.
Angle (in degrees) of the segment formed by the center of the hole and the thread entry point
with respect to the abscissa axis.
N Number of cutter edges
It defines the number of cutting edges of the cutter (only when machining with a cutter of n
edges).
δ
K
B
φ
Zs
P