4 - Fagor Automation

Canned cycles (·M· model)
P.XY Name of the surface profile or plane profile.
It must indicate all the contours.
For the outside contour, the one for the surface (1).
For the islands, the one for the base (2).
All the contours must be closed and must not intersect themselves.
Remember that the order in which the contours are defined is very important.
P.Z1 P.Z2 P.Z3 P.Z4
Name of the depth profiles.
They corresponds to the first 4 contours defined in the surface profile, the number
indicates the order.
To define the depth profile, use one of the axis of the plane and the perpendicular axis.
Use the same point to define the beginning of the contour and the beginning of the
depth contour.
For the outside contour, one for the surface (1).
For the islands, one for the base (2).
All the profiles must be open and without direction changes along their travel (not
zigzagging).
Vertical depth profiles for the outside contour and for the islands that reach the surface
plane need not be programmed.
The figure shows three programming examples.
4.
CANNED CYCLES OF THE EDITOR
'3D profile pocket with islands.
CNC 8065
(REF: 1209)
·149·