4 - Fagor Automation
4 - Fagor Automation
4 - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Canned cycles (·M· model)<br />
The finishing operation defining parameters are:<br />
δ Finishing stock on the side walls.<br />
δz Finishing stock at the bottom of the pocket.<br />
Δ Milling pass or width at the bottom of the pocket.<br />
The cycle recalculates the pass so that all the passes are identical, with the same value as<br />
or smaller than the one programmed. If programmed with a 0 value, it assumes a value of 3/4<br />
of the diameter of the selected tool.<br />
N Number of penetration passes (steps) for the side finishing. If the resulting step is greater than<br />
the cutting length assigned to the table in the tool table, the step will be limited to that value.<br />
θ Penetrating angle.<br />
The penetration is carried out along a helical path at the feedrate set by roughing parameter<br />
"Fz" starting and ending at the center of the pocket. If defined with a value greater than the<br />
one assigned to the tool in the tool table, it assumes the table value.<br />
F Surface and side milling feedrate.<br />
S Spindle speed.<br />
T Finishing tool.<br />
If programmed T=0, there is no finishing.<br />
D Tool offset.<br />
Spindle turning direction (icon).<br />
Clockwise.<br />
Counterclockwise.<br />
4.<br />
CANNED CYCLES OF THE EDITOR<br />
Circular pocket.<br />
CNC 8065<br />
(REF: 1209)<br />
·131·