4 - Fagor Automation

Canned cycles (·M· model)
T Roughing tool.
If programmed T=0, there is no roughing.
Spindle turning direction (icon).
Clockwise.
Counterclockwise.
Programming of M functions.
Activating or deactivating the execution of M functions before machining. The cycle allows
editing up to 4 M functions. To execute only some of them, define them first and leave the
rest of the data unprogrammed.
The editor will only show this option if the user has configured the editor to allow
programming M functions.
Finishing parameters:
The finishing operation is carried out in two stages. First, it machines the bottom of the pocket
and then the side walls, with tangential entry and exit.
The finishing operation defining parameters are:
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
Δ Milling pass or width at the bottom of the pocket.
The cycle recalculates the pass so that all the passes are identical, with the same value as
or smaller than the one programmed. If programmed with a 0 value, it assumes a value of 3/4
of the diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing.
When programming a 0 value, it carries out the least amount of passes possible, considering
the cutting length assigned to the tool in the tool table.
θ Penetrating angle.
The penetration is carried out at the feedrate set by roughing parameter "Fz" maintaining this
angle until reaching the corresponding depth. If defined with a value greater than the one
assigned to the tool in the tool table, it assumes the table value.
4.
CANNED CYCLES OF THE EDITOR
2D profile pocket.
CNC 8065
(REF: 1209)
·141·