4 - Fagor Automation

4.
CANNED CYCLES OF THE EDITOR
CNC 8065
(REF: 1209)
·152·
'3D profile pocket with islands.
The pre-finishing operation defining parameters are:
Spindle turning direction (icon).
Clockwise.
Programming of M functions.
Finishing parameters:
Canned cycles (·M· model)
I2 Penetration step.
If programmed with a positive sign (I+), the cycle recalculates the step so all the
penetrations are identical with the same value as or smaller than the one programmed.
If programmed with a negative sign (I-), the pocket is machined with the given pass (step)
except the last pass that machines the rest.
In either case, the cycle limits the step to the cutting length assigned to the tool in the tool table.
F Milling feedrate.
S Spindle speed.
T Pre-finishing tool.
If programmed T=0, there is no pre-finishing.
D Tool offset.
Counterclockwise.
Activating or deactivating the execution of M functions before machining. The cycle allows
editing up to 4 M functions. To execute only some of them, define them first and leave the
rest of the data unprogrammed.
The editor will only show this option if the user has configured the editor to allow
programming M functions.
The finishing operation takes into account the geometry of the tool tip. It compensates the
tool tip radius defined in the table.
δ Finishing stock on the side walls.
ε Milling pass or width for the side walls.
Machining direction for the side walls (icon).
Always downwards.
Always upwards.
In zig-zag.
F Milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
Spindle turning direction (icon).
Clockwise.
Counterclockwise.