4 - Fagor Automation

MILLING CANNED CYCLES.
1.1 General concepts
1
Some canned cycles are edited in ISO code (described in this chapter) and others are
generated in conversational mode (described in chapter "4 Canned cycles of the editor")
The canned cycles edited in ISO code are defined using a "G" function and its relevant
parameters.
G81 Drilling canned cycle.
G82 Drilling canned cycle with variable peck (drilling step).
G83 Deep hole drilling canned cycle with constant peck (drilling step).
G84 Tapping canned cycle.
G85 Reaming canned cycle.
G86 Boring canned cycle.
G87 Rectangular pocket canned cycle.
G88 Circular pocket canned cycle.
G210 Bore milling canned cycle
G211 Inside thread milling canned cycle.
G212 Outside thread milling canned cycle.
Other functions related to canned cycles:
G80 Canned cycle cancellation.
G98 The tool, after the canned cycle is done, returns to the starting plane.
G99 The tool, after the canned cycle is done, returns to the reference plane.
Machining cycles may be executed in any plane. The penetration is carried out along the
longitudinal axis, selected with function G20 or with the instruction "#TOOL AX", or when
missing, along the axis perpendicular to the active plane.
Combined (dual-purpose) machines Milling and turning canned
cycles available at the same CNC.
On dual-purpose machines, those where milling and turning operations may be carried out,
the CNC offers the possibility to run canned cycles of both machines. Since both types of
canned cycles share the same ·G· functions, the user can select which cycles to execute.
By default, it executes the cycles of the software installed.
CNC 8065
(REF: 1209)
·23·