4 - Fagor Automation

Canned cycles (·M· model)
4.11.1 Basic operation.
1 It starts the spindle in the requested direction.
2 Rapid movement (G0) to the center of the pocket and the safety plane (Zs). Depending
on the starting plane, it first moves in XY and then in Z or vice versa.
3 Rapid movement (G0) up to the approach plane.
4 First penetration, the "Fz" feedrate, the amount "I".
5 Milling of the pocket surface.
Roughing is carried out at feedrate "F" with the passes defined by "Δ" and up to a distance
"δ" from the pocket wall. The finishing pass "δ" is carried out with tangential entry and
exit and at feedrate "F".
6 Rapid withdrawal (G0) to the center of the pocket in the approach plane.
7 New milling surfaces until reaching the total depth of the pocket.
Penetration, at the feedrate indicated in "Fz" up to a distance "I" from the previous surface.
Milling of the new surface following the steps indicated in points 5 and 6.
8 Rapid withdrawal (G0) up to the safety plane (Zs).
If it has a multiple machining operation associated with it, it executes the following steps as
often as necessary:
9 Rapid movement (G0) to the next point.
10 Repeats steps 3, 4, 5, 6, 7, 8.
4.
CANNED CYCLES OF THE EDITOR
Simple rectangular pocket.
CNC 8065
(REF: 1209)
·123·