4 - Fagor Automation

4.
CANNED CYCLES OF THE EDITOR
CNC 8065
(REF: 1209)
·96·
Canned cycles available in the editor.
Canned cycles (·M· model)
4.1.4 Associate a multiple machining operation with a canned cycle
FOCUS
At the cycle editor, a multiple machining operation may be associated with the following
cycles:
Center punching, drilling, deep hole drilling, bore milling, tapping, thread milling,
reaming, boring, boring with spindle orientation.
Simple rectangular pocket, rectangular pocket with rounding, circular pocket and preemptied
circular pocket.
Rectangular boss and circular boss.
How to select multiple machining.
To associate multiple machining to a cycle, first select and define a
machining cycle from those allowed. Then, without quitting the editing of
the cycle, press the softkey associated with multiple machining and select
one of them.
The next figure shows the drilling cycle (top) with a multiple linear machining operation
associated with it (bottom). To edit the data of the canned cycle or of the multiple machining
operation, select the relevant window using the [FOCUS] key.
When the canned cycle takes up the whole screen, the multiple machining operation is superimposed
on it as shown in the figure. In these cases, while editing the cycle data, the top
window is shifted automatically to show the data.