4 - Fagor Automation
4 - Fagor Automation
4 - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Canned cycles (·M· model)<br />
I Penetration step.<br />
If programmed with a positive sign (I+), the cycle recalculates the step so all the<br />
penetrations are identical with the same value as or smaller than the one programmed.<br />
If programmed with a negative sign (I-), the boss is machined with the given pass (step)<br />
except the last pass that machines the rest.<br />
In either case, the cycle limits the step to the cutting length assigned to the tool in the tool table.<br />
Fz Penetration feedrate.<br />
F Surface milling feedrate.<br />
S Spindle speed.<br />
T Roughing tool.<br />
If programmed T=0, there is no roughing.<br />
D Tool offset.<br />
Spindle turning direction (icon).<br />
Clockwise.<br />
Counterclockwise.<br />
Machining direction (icon).<br />
Clockwise.<br />
Counterclockwise.<br />
Programming of M functions.<br />
Activating or deactivating the execution of M functions before machining. The cycle allows<br />
editing up to 4 M functions. To execute only some of them, define them first and leave the<br />
rest of the data unprogrammed.<br />
The editor will only show this option if the user has configured the editor to allow<br />
programming M functions.<br />
Finishing parameters:<br />
The finishing operation is carried out in two stages. First, it machines the base of the boss<br />
and then the side walls, with tangential entry and exit.<br />
The finishing operation defining parameters are:<br />
δ Finishing stock on the side walls.<br />
δz Finishing stock at the base of the boss.<br />
N Number of penetration passes (steps) for the side finishing. If the resulting step is greater than<br />
the cutting length assigned to the table in the tool table, the step will be limited to that value.<br />
F Surface and side milling feedrate.<br />
S Spindle speed.<br />
T Finishing tool.<br />
If programmed T=0, there is no finishing.<br />
4.<br />
CANNED CYCLES OF THE EDITOR<br />
Circular boss.<br />
CNC 8065<br />
(REF: 1209)<br />
·165·