4 - Fagor Automation

4.
CANNED CYCLES OF THE EDITOR
CNC 8065
(REF: 1209)
·172·
Point-to-point profile milling.
4.20 Point-to-point profile milling.
Canned cycles (·M· model)
The way the roughing and finishing blocks of this cycle are joined will be the one previously
set by the user with the instructions #HSC, G5, G50 or G7. We recommend to use #HSC
or G5 controlling the shape of the corner with the instruction #ROUNDPAR.
Geometric parameters:
X1, Y1 Profile entry point
R1 Radius of the tangential entry to the profile
P1..P25 Points of the profile.
All intermediate points P2 to P24 have an icon to indicate the type of corner; square,
rounded or chamfered. For rounded or chamfered corners, indicate the rounding
radius or chamfer size.
When not using all 25 points, define the first unused point with the same coordinates
as those of the last point of the profile.
Delete all the points of the profile. Select this icon and press [DEL] to delete all the points
of the table.
Rn Radius of the tangential exit from the profile
Xn, Yn Profile exit point
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
Roughing parameters:
The roughing operation mills the profile leaving the finishing stock δ. This stock is defined
as finishing parameter.