4 - Fagor Automation

Canned cycles (·M· model)
F Surface milling feedrate.
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
D Tool offset.
Spindle turning direction (icon).
Clockwise.
Counterclockwise.
Machining direction (icon).
Clockwise.
Counterclockwise.
Programming of M functions.
Activating or deactivating the execution of M functions before machining. The cycle allows
editing up to 4 M functions. To execute only some of them, define them first and leave the
rest of the data unprogrammed.
The editor will only show this option if the user has configured the editor to allow
programming M functions.
Finishing parameters:
The finishing operation is carried out in two stages. First, it machines the bottom of the pocket
and then the side walls, with tangential entry and exit.
The finishing operation defining parameters are:
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
Δ Milling pass or width at the bottom of the pocket.
The cycle recalculates the pass so that all the passes are identical, with the same value as
or smaller than the one programmed. If programmed with a 0 value, it assumes a value of 3/4
of the diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing. If the resulting step is greater than
the cutting length assigned to the table in the tool table, the step will be limited to that value.
Fz Penetration feedrate.
θ Penetrating angle.
The penetration is carried out along a helical path at the feedrate set by finishing parameter
"Fz" starting and ending at the center of the pocket. If defined with a value greater than the
one assigned to the tool in the tool table, it assumes the table value.
4.
CANNED CYCLES OF THE EDITOR
Pre-emptied circular pocket.
CNC 8065
(REF: 1209)
·135·