4 - Fagor Automation

Canned cycles (·M· model)
3.3 Selecting data, profiles and icons
Data selection.
To enter or modify a data, it must be selected; i.e. it must have the editing focus on it.
The parameters of the cycles may be selected with the [] [] [] [] keys or with the direct
access keys. The first data of each group may also be selected by pressing the page-up and
page-down keys.
The direct access keys correspond to the name of the parameters; [F] for feedrates, [T] for
tools, etc. Every time the same key is pressed, it selects the next data of the same type.
Data entry.
Place the cursor in the corresponding window, key in the desired value and press [ENTER].
If [ENTER] is not pressed, the new value will not be assumed.
If the Teach-in mode is selected, the current position of the machine may be associated with
a coordinate. Place the cursor in the relevant window and press the [RECALL] key.
For the X axis parameters, it will take the coordinate of the first axis of the channel where
the edit-simulation mode is active. For the Y axis parameters, the coordinate of the second
axis and for the Z axis parameters, the coordinate of the third one.
Changing the state of an icon.
Place the cursor on the desired icon and press the space bar.
Select - Define a profile.
To select or modify a profile, the corresponding data must be selected; i.e. it must have the
editing focus on it.
To select an existing profile, press the [] key to expand the list of defined profiles and
select one or type its name.
To define a new profile, write the desired name and press the [RECALL] key to access
the profile editor.
To modify an existing profile, select it from the list or write its desired name and press
the [RECALL] key to access the profile editor.
To delete a profile, press the [] key to expand (drop) the list of profiles and select one.
Press the [DEL] key to delete it.
3.
CYCLE EDITOR
Selecting data, profiles and icons
CNC 8065
(REF: 1209)
·87·