5800 Refrigerated Sampler Service Guide - Isco

5800 Refrigerated Sampler Service Guide
Section 1 Introduction and General Maintenance
1.2 Technical
Specifications
Table 1-1 contains technical specifications for the 5800 sampler.
Table 1-1 5800 Technical Specifications
Size (HWD): 130 72 84 cm 52 29 33 in
Weight (empty): 83.5 kg 184 lb
Bottle Configurations:
Refrigerator Body:
Power Requirements:
Installation Category:
Pollution Degree: 3
Maximum Altitude a :
Humidity: 0 to 100%
13 configurations available:
24, 1-liter PP
24, 350-ml glass
4, 10-liter PE or glass
4, 20-liter PE
2, 10-liter PE or glass
1, 20-liter PE or glass
1, 10-liter PE or glass
24 ProPaks, 1-liter wedge
1 ProPak, 10-liter round
Linear low-density polyethylene (LLDPE)
115 VAC ±10%, 60 Hz Sampler
Running current 4 amperes
Stopped current 22 amperes
230 VAC ±10%, 50 Hz Sampler
Running current 2 amperes
Stopped current 17 amperes
II
2,000 meters 6,562 feet
Operational Temperature: –29 to 49 °C –20 to 120 °F
Pump
Intake Suction Tubing Length: 1 to 30 m 3 to 99 feet
Material:
Suction Line Inside Diameter:
Pump Tubing Life:
Vinyl or FEP-lined polyethylene
9 mm
Typically 1,000,000 pump counts.
3 /8 inch
Maximum Suction Lift: 8.5 m 28 feet
Typical Repeatability
(Ability to repeat the delivered volume
for a set of samples collected under
the same conditions.):
Typical Delivered Volume Accuracy:
±5ml or ±5% of the average volume in a set, whichever is greater, at lifts up to
25 feet.
±10ml or ±10% of programmed value, whichever is greater.
Typical Line Velocity at Head Height: 0.9 m: 0.91 m/s 3 ft: 3.0 ft/s
3.1 m: 0.87 m/s 10 ft: 2.9 ft/s
4.6 m: 0.83 m/s 15 ft: 2.7 ft/s
7.6 m: 0.67 m/s 25 ft: 2.2 ft/s
Speed:
Approx. 300 RPM, depending on sampling conditions
1-2