5800 Refrigerated Sampler Service Guide - Isco

More documents

Recommendations

Info

5800 Refrigerated Sampler Service Guide Section 1 Introduction and General Maintenance Cut cable tie Figure 1-8 Cut cable tie from line cord (Full line cord length not depicted) 4. Remove the refrigeration module mounting screws. Note that the refrigeration module has an adhesive strip just above the rear coils. The bottom center screw may be slightly hidden by this strip. 5. Carefully pull the module out and rotate clockwise to expose the wiring connectors (Figure 1-9). CAUTION During removal, keep the module as close to the refrigerator body as possible to avoid pulling the wiring taut and damaging the connectors. Turn module out and left Adhesive strip Figure 1-9 Remove the refrigeration module mounting screws 1-16
5800 Refrigerated Sampler Service Guide Section 1 Introduction and General Maintenance 1.8 Closing the Rear Compartment Ensure that the control wiring runs through the notches in the plastic refrigerator body. The refrigeration module and rear compartment of the cabinet have adhesive strips and Permagum 1 (caulking cord sealant) protecting the components (Figures 1-11 and 1-10). Ensure that all adhesive strips and Permagum are still in place before reassembly. CAUTION The adhesive strips and Permagum are required to prevent air flow between the condenser coil and the evaporator plate. Without this protection, water condensation on the coil will cause ice build-up, resulting in poor refrigerator performance and inability to shut off. Note Two thick, black cables connect the power supply with the AC and compressor (see Figure 1-10). Ensure that these cables are side by side and not crossed during reassembly. Permagum sealant Power supply cables Adhesive strips Figure 1-10 Rear view with module removed (Adhesive strips, Permagum sealant, power cables) 1. Permagum is a registered trademark of the Presstite Engineering Company. 1-17
Page 1: 5800 Refrigerated Sampler Service G
Page 4 and 5: Isco 5800 Refrigerated Sampler Serv
Page 6 and 7: Isco 5800 Refrigerated Sampler Serv
Page 8 and 9: 5800 Refrigerated Sampler Service G
Page 78 and 79:
5800 Refrigerated Sampler Service G
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
5800 Refrigerated Sampler Electrica
Page 124 and 125:
5800 Refrigerated Sampler Electrica
Page 126 and 127:
Isco 5800 Refrigerated Sampler Serv
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172:
show all

5800 Refrigerated Sampler Service Guide - Isco

Create successful ePaper yourself

Delete template?

Save as template?