5800 Refrigerated Sampler Service Guide - Isco

5800 Refrigerated Sampler Service Guide
Section 1 Introduction and General Maintenance
5. Start Flowlink’s application Update Software.
a. From the computer START menu, select PROGRAMS,
and highlight Flowlink.
b. Select Update Software.
6. Follow the update instructions in the Update Software
Help menu.
1.5.2 Software Reset If the 5800 does not appear to be operating normally, you can
restart the processor by turning the unit off, waiting a few
minutes, and then turning the unit back on. If the problem
recurs, you can reset the software.
CAUTION
This procedure will cause most programmed entries and accumulated
data stored in the sampler to be lost, and the sampler
will revert to factory default settings. If this operation is performed,
it will be necessary for you to reprogram the unit to
meet the specifications of your installation. Record your program
settings and download any data before performing a software
reset.
To reset the software:
1. Disconnect power to the sampler.
2. Hold down the Stop and Enter buttons together and reconnect
the power.
1.5.3 System IDs Select this option to view the system IDs. This function reports
the unique ID for the sampler, and its hardware and software
versions. These IDs are factory set.
SELECT OPTION: ()
SYSTEM IDs
5800 Sampler
ID: ___________
HARDWARE: ___
SOFTWARE: _._
1. Select the SYSTEM IDs option and press Enter.
2. The first line lists the model number. The second line lists
the unique ID for the sampler. Press Enter to continue.
This screen lists the version numbers of the installed hardware
and software. Press Enter to return to the
SELECT OPTION screen.
1-12