NPL-352 Manual-09.pdf

Applications 4
Recording Measurement Data 4.1
Recording data from any observation screen 41.1
To record points on observation screens, press
[ENT].
PT defaults to the last recorded PT + 1.
You can enter the PT name from the point list or
the point stack. For more information, see
Entering a point from the point list, page 52, and
Entering a point from the stack, page 52.
You can also use the code list or the code stack. For more information, see Entering
a code from the code list, page 53, and Entering a code from the stack, page 53.
To record the point, press [ENT] on the last field.
When recording sideshots, stakeout records and
control shots from the Rept function, you can
choose to store raw data only, XYZ data only, or
both. For more information, see Recording,
page 139.
If HA or VA is moved after you take a measurement but before you press [ENT], the
angle recorded is the angle shown when [ENT] is pressed.
In an angle-only record, SD is always recorded as 0.0000.
If the point name that you want to record already
exists in the job, an error message appears.
Depending on the type of existing record, you can
overwrite the old record with the new data. For
more information, see Recording Data, page 210.
Hold down [ENT] for one second to record the
measurement as a CP record.
Pulse Laser Station NPL-302 Series Instruction Manual 103