NPL-352 Manual-09.pdf

2 Preparation
Setting Up the Prism Reflector 2.3
The prism reflector is also for measurements in Prism mode.
1. Assemble the prism reflector as shown in Figure 2.4.
Target plate for single prism
Target plate for single prism
Tribrach adapter 13/14 13/14
Leveling Leveling base W10/W11 base
Tiltable single
prism holder
Prism C
Tripod
Figure 2.4
Assembling the prism reflector
2. Adjust the height of the tribrach adaptor (see page 23).
3. If necessary, change the direction of the prism (see page 23).
4. Set the prism constant (see page 23).
5. Set the position of the target plate (see page 24).
Detailed instructions for Step 2 through Step 5 are provided on the following pages.
22 Pulse Laser Station NPL-302 Series Instruction Manual