NPL-352 Manual-09.pdf

10 Error Messages
Settings 10.11
Job Settings will be changed 1011.1
You have changed one or more of the following job settings:
• VA zero or HA in the Angle screen (see Angle, page 135)
• Scale, T-P, Sea Lvl, or C&R in the Distance screen (see Distance, page 136)
• Coord or Az Zero in the Coordinates screen (see Coordinate, page 138)
• Angle, Dist, Temp, or Press in the Unit screen (see Unit, page 139)
To ... Press ...
discard the changes to the job settings [ESC] or the Abrt softkey. The
current job remains open.
close the current job and save the changes [ENT] or the OK softkey
to the job settings
Note – To record a point using the new settings, create a new job using the new
settings.
Stakeout 10.12
Input Error 1012.1
The point name style used in the Fr field is not the same as the style used in the To
field. For example, the Fr field style is 1, and the To field style is A200.
Press any key to return to the Fr/To input screen. Then re-enter the point name,
using the same naming style in both fields.
NO Stn Setup 1012.2
You did not perform a station setup or BS check before entering the Stakeout
function.
To... Press ...
go to the Stn Setup menu [2] or select Stn Setup
return to the Basic
[ESC]
Measurement Screen (BMS)
go to the Stakeout menu [1] or select Continue
212 Pulse Laser Station NPL-302 Series Instruction Manual