NPL-352 Manual-09.pdf
NPL-352 Manual-09.pdf
NPL-352 Manual-09.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 Preparation<br />
• To prevent malfunction, keep the charging plug clean.<br />
• If the CHARGE indicator blinks repeatedly after charging starts, there is a<br />
problem with the battery pack. Do not use or charge the battery pack any further,<br />
and contact your dealer.<br />
• If the ambient temperature drops below 0 °C (32 °F) while the battery pack is<br />
charging, the charger stops charging the battery pack. When the ambient<br />
temperature rises above 0 °C (32 °F), charging resumes. Charging will be<br />
completed after restarting.<br />
• If the CHARGE indicator remains lit for more than four hours, and the ambient<br />
temperature during charging was within the specified operational range<br />
(0 °C through 40 °C or 32 °F through 104 °F), there is a problem with the<br />
battery pack. Do not use or charge the battery pack any further, and contact your<br />
dealer.<br />
• During charging or discharging, the battery pack and quick charger will become<br />
warm. This is normal.<br />
• After charging the battery pack, do not recharge it until it has been fully<br />
discharged. Recharging a fully charged battery pack lowers its performance.<br />
• If the battery pack is used at low temperatures (below –20 °C or –4 °F), its<br />
capacity is reduced, and it will allow less operation time than a battery pack<br />
used at normal (room) temperature.<br />
• If a battery pack is not used for a long period, it cannot be charged to its full<br />
capacity again. To improve the battery pack’s capacity, charge and discharge it<br />
several times.<br />
• You can use a battery charger with part number Q-70U/E or Q-70C to charge a<br />
battery pack with part number BC-65. However, these chargers cannot fully<br />
charge this battery pack.<br />
Charging the battery pack<br />
1. Connect the power plug on the charger to<br />
an AC power outlet.<br />
2. Connect the charging plug on the charger<br />
cable to the charging connector on the<br />
battery pack.<br />
The CHARGE indicator lights up, and<br />
charging starts automatically.<br />
When the battery pack is fully charged, the<br />
CHARGE indicator turns off.<br />
To AC outlet<br />
Air holes<br />
CHARGE<br />
indicator<br />
DISCHARGE<br />
indicator<br />
DISCHARGE<br />
button<br />
12 Pulse Laser Station <strong>NPL</strong>-302 Series Instruction <strong>Manual</strong>
Change language