NPL-352 Manual-09.pdf

Getting Started 3
In Quick code measurement, the Rec mode can only be set to Confirm or ALL.
[HOT] key 30.2
The HOT key menu is available on any
observation screen. To display the HOT key
menu, press [HOT].
Changing the height of the target
To change the height of the target, press [HOT] to
display the HOT menu. Then either press [1] or
select HT and press [ENT].
Enter the height of the target, or press the Stack
softkey to display the HT stack. The HT stack
stores the last 20 HT values entered.
Setting the temperature and pressure
To set the current temperature and pressure, press
[HOT] to display the HOT menu. Then either press
[2] or select Temp-Press and press [ENT]. Enter
the ambient temperature and pressure. The ppm
value is updated automatically.
Selecting the target set
A target set specifies settings for the target type,
the prism constant, and height of target. When you
change the selected target set, all three settings are
changed. You can use this function to quickly
switch between two types of target, such as a
reflector sheet and a prism. You can prepare up to
five target sets.
Press [HOT] to display the HOT menu. Then either press [3], or select Target and
press [ENT]. A list of the five target sets appears. To select a target set, either press the
corresponding numeric key ([1] through [5]), or use [^] or [v] to highlight the target set
in the list and press [ENT].
Pulse Laser Station NPL-302 Series Instruction Manual 43