CSDP Plus Servo Drive User Manual

When this parameter is set, the values of the basic gain will change
after referring to the inertia ratio (SEt-66).
• System Gain (SEt-42)
SEt-71 DA Monitor Channel 1 Offset
• Setting range: 0 to 1000, 10000 to 11000 mV
• Factory Default: 0
• Changes anytime
SEt-72 DA Monitor Channel 1 Output Gain
• Setting range: 0 to 1000, 10000 to 11000 mV
• Factory Default: 0
• Changes anytime
SEt-73 DA Monitor Channel 2 Offset
• Setting range: 0 to 1000, 10000 to 11000 mV
• Factory Default: 0
• Changes anytime
SEt-74 Monitor Channel 2 Output Gain
• Setting range: 0 to 1000, 10000 to 11000 mV
• Factory Default: 0
• Changes anytime
The setting of SEt-71 to 74 is used for the offset of analog monitor and
the control of output gain.
As the values between 0 to 1000 mV are entered, it becomes +offset, in
the case of the values between 10000 to 11000 mV, it becomes - offset.
(1 on the fifth digit means ’-’.)
174