CSDP Plus Servo Drive User Manual

SEt-75 Overload Curve Level
• Setting range: 50 to 300%
• User Default: 100
• Changes while the servo is OFF
The level of overload curves of driver can be controlled.
SEt-76 Output Signal Assignment 1
• Setting range: 0 x 0000 to 0 x 3333
• User Default: 0 x 0321
• Change while the servo is OFF, and turn off the power and turn it back on
Output signals to be used at the CN1 connector’s output pins from
DO#1 to DO#3 should be allocated.
Output Signal Allocation Table
Parameter Fourth Digit Third Digit Second Digit First Digit
SEt-76 /V-COM /BK /TG-ON /P-COM
SEt-77 /WARN /NEAR /V-LMT /T-LMT
Put 1 in the first digit of SEt-76 to allocate /P-COM signal to the DO#1
pin.
Put 3 in the fourth digit of SEt-77 to use /WARN function through DO#3
pin.
Setting 0 makes the system always invalid and there is no value to
make the system always valid, which is different from the input case.
SEt-77 Output Signal Assignment 2
• Setting range: 0 x 0000 to 0 x 3333
• User Default: 0 x 0000
• Change while the servo is OFF, and turn off the power and turn it back on
175