Volume 8 – Mechanical and Electrical Services - Malaysia Geoportal

More documents

Recommendations

Info

Chapter 2 GATE DESIGN Installation Work Tilting Gate and Hydraulic Cylinder a) Assemble the various parts for the gate, namely, the side seals, shaft and bearing. b) Before lowering the gate into position, it is prudent to grease the seals in order to protect them from damage. c) Lower the gate into position by using of a mobile crane and locate the bearing blocks into the prepared anchor bolts as shown in the drawings. Finally, tighten bolts. d) After that the gate seals can be installed. e) Next, install the hydraulic cylinders to the cylinder pivot and locate the assembly at the prepared hydraulic pivot anchor site. Tighten the bolts. f) Finally, attach the hydraulic arms to their respective brackets on the gate. 9.0 METHOD OF MEASUREMENT The total numbers of equipment to be installed. 10.0 APPROVAL All documents or drawings, which are stated within this method statement, shall be approved or reviewed by consultant prior to installation works. 11.0 SAFETY STATEMENT Refer to Job Safety Analysis 12.0 QUALITY All inspection shall be in accordance to the approved Inspection and Test Plan. March 2009 2A-3
Chapter 2 GATE DESIGN APPENDIX 2B METHOD STATEMENT FOR TILTING GATE GUIDE INSTALLATION TABLE OF CONTENTS 1.0 GENERAL 2.0 SCOPE 3.0 REFERENCE 4.0 RESPONSIBILITIES 5.0 REFERENCE DRAWING 6.0 EQUIPMENTS & MACHINERIES REQUIRED 7.0 MANPOWER 8.0 SEQUENCE OF WORK 9.0 METHOD OF MEASUREMENT 10.0 APPROVAL 11.0 SAFETY STATEMENT 12.0 QUALITY 2A-4 March 2009
Page 1 and 2:
GOVERNMENT OF MALAYSIA DEPARTMENT O
Page 3 and 4:
DID MANUAL VOLUME 8 Foreword The fi
Page 5 and 6:
DID MANUAL VOLUME 8 Registration of
Page 7 and 8:
DID MANUAL VOLUME 8 List of Volumes
Page 9 and 10:
DID MANUAL VOLUME 8 TNB TSHD USBR T
Page 12 and 13:
Chapter 1 PUMPING INSTALLATION Tabl
Page 14 and 15:
Chapter 1 PUMPING INSTALLATION Figu
Page 16 and 17:
1.1 TYPE OF PUMPS USED IN DID Chapt
Page 18 and 19:
Chapter 1 PUMPING INSTALLATION Fig.
Page 20 and 21:
Chapter 1 PUMPING INSTALLATION Wate
Page 22 and 23:
Page 24 and 25:
Chapter 1 PUMPING INSTALLATION Moni
Page 26 and 27:
Chapter 1 PUMPING INSTALLATION b) P
Page 28 and 29:
Chapter 1 PUMPING INSTALLATION 1.9
Page 30 and 31:
Page 32 and 33:
Chapter 1 PUMPING INSTALLATION a) W
Page 34 and 35:
Chapter 1 PUMPING INSTALLATION c) A
Page 36 and 37: Chapter 1 PUMPING INSTALLATION Fig
Page 38 and 39: Chapter 1 PUMPING INSTALLATION Gene
Page 40 and 41: Chapter 1 PUMPING INSTALLATION Fig
Page 42 and 43: Chapter 1 PUMPING INSTALLATION Comm
Page 44 and 45: Chapter 1 PUMPING INSTALLATION - In
Page 46 and 47: Chapter 1 PUMPING INSTALLATION APPE
Page 48 and 49: Chapter 1 PUMPING INSTALLATION (6)
Page 50: 1 CHAPTER 2 GATE DESIGN
Page 53 and 54: Chapter 2 GATE DESIGN APPENDIX 2B M
Page 55 and 56: Chapter 2 GATE DESIGN (This page is
Page 57 and 58: Chapter 2 GATE DESIGN a) Dam - rete
Page 59 and 60: Chapter 2 GATE DESIGN Figure 2.5 He
Page 61 and 62: Chapter 2 GATE DESIGN g) Offtake -
Page 63 and 64: Chapter 2 GATE DESIGN Figure 2.9(c)
Page 65 and 66: Chapter 2 GATE DESIGN Some common r
Page 67 and 68: Chapter 2 GATE DESIGN Figure 2.13 T
Page 69 and 70: Chapter 2 GATE DESIGN b) High press
Page 71 and 72: Chapter 2 GATE DESIGN Figure 2.18 H
Page 73 and 74: Chapter 2 GATE DESIGN Bulkhead gate
Page 75 and 76: Chapter 2 GATE DESIGN Table 2.1 Cor
Page 77 and 78: 2.4.1 Materials for Hydraulic Gates
Page 79 and 80: Chapter 2 GATE DESIGN Corrosion mit
Page 81 and 82: Chapter 2 GATE DESIGN 2.6 GATE TEST
Page 85: Chapter 2 GATE DESIGN 1.0 GENERAL T
Page 89 and 90: Chapter 2 GATE DESIGN a) Sill Beam
Page 91 and 92: 1.0 PURPOSE Chapter 2 GATE DESIGN A
Page 93 and 94: Chapter 2 GATE DESIGN 5.0 Fully Ope
Page 95 and 96: Chapter 2 GATE DESIGN Section 5 Tro
Page 100 and 101: Chapter 3 GROUND WATER FACILITIES T
Page 102 and 103: 3.1 INTRODUCTION Chapter 3 GROUND W
Page 104 and 105: Chapter 3 GROUND WATER FACILITIES F
Page 106 and 107: Chapter 3 GROUND WATER FACILITIES O
Page 108 and 109: Chapter 3 GROUND WATER FACILITIES D
Page 110 and 111: Chapter 3 GROUND WATER FACILITIES T
Page 112: CHAPTER 4 OCCUPATIONAL SAFETY AND H
Page 115 and 116: Chapter 4 OCCUPATIONAL SAFETY AND H
Page 130 and 131: Chapter 5 PLANT MANAGEMENT AND CONT
Page 132 and 133: 5.1 INTRODUCTION Chapter 5 PLANT MA
Page 134 and 135: Chapter 5 PLANT MANAGEMENT AND CONT
Page 136 and 137:
Chapter 5 PLANT MANAGEMENT AND CONT
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152:
CHAPTER 6 ENERGY EFFICIENCY IN MANA
Page 155 and 156:
Chapter 6 ENERGY EFFICIENCY IN MANA
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Device in the Solar Panel Chapter 6
Page 168 and 169:
Chapter 7 ELECTRICAL SERVICES Table
Page 170 and 171:
Chapter 7 ELECTRICAL SERVICES List
Page 172 and 173:
Chapter 7 ELECTRICAL SERVICES 7 ELE
Page 174 and 175:
Chapter 7 ELECTRICAL SERVICES The d
Page 176 and 177:
Chapter 7 ELECTRICAL SERVICES If we
Page 178 and 179:
Chapter 7 ELECTRICAL SERVICES The r
Page 180 and 181:
Chapter 7 ELECTRICAL SERVICES 7.3 4
Page 182 and 183:
Chapter 7 ELECTRICAL SERVICES 7.3.5
Page 184 and 185:
Chapter 7 ELECTRICAL SERVICES Table
Page 186 and 187:
Chapter 7 ELECTRICAL SERVICES The r
Page 188 and 189:
Chapter 7 ELECTRICAL SERVICES APPEN
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Chapter 7 ELECTRICAL SERVICES (d) (
Page 198 and 199:
Chapter 7 ELECTRICAL SERVICES (cont
Page 200:
CHAPTER 8 DREDGER
Page 203 and 204:
Chapter 8 DREDGER List of Tables Ta
Page 205 and 206:
Chapter 8 DREDGER d) Beach nourishm
Page 207 and 208:
Chapter 8 DREDGER As a backup syste
Page 209 and 210:
Chapter 8 DREDGER Fig. 8.5 Cutter S
Page 211 and 212:
8.4 EQUIPMENT OF DREDGER Typical Dr
Page 213 and 214:
Chapter 8 DREDGER Table 8.3 - Dispo
Page 215 and 216:
Chapter 8 DREDGER 3.2 Speed Boat -
Page 217 and 218:
Chapter 8 DREDGER 3.0 Supervision C
Page 219 and 220:
Chapter 8 DREDGER ii. Where there i
Page 221 and 222:
Chapter 8 DREDGER ‣ Synthetic rop
Page 223 and 224:
8.12 OPERATION & MAINTENANCE Manual
Page 225 and 226:
Chapter 8 DREDGER • Check the lev
Page 228 and 229:
Chapter 9 ASSET MANAGEMENT Table of
Page 230 and 231:
Chapter 9 ASSET MANAGEMENT 9.4.6.5
Page 232 and 233:
Chapter 9 ASSET MANAGEMENT 9 ASSET
Page 234 and 235:
Chapter 9 ASSET MANAGEMENT 9.2.4 Pe
Page 236 and 237:
Chapter 9 ASSET MANAGEMENT 9.3.2 Tu
Page 238 and 239:
Page 240 and 241:
Chapter 9 ASSET MANAGEMENT Fig. 9.2
Page 242 and 243:
Page 244 and 245:
Chapter 9 ASSET MANAGEMENT Kementer
Page 246 and 247:
Chapter 9 ASSET MANAGEMENT Table 9.
Page 248 and 249:
Chapter 9 ASSET MANAGEMENT • Pega
Page 250 and 251:
Chapter 9 ASSET MANAGEMENT f) Mempe
Page 252 and 253:
9.4.5.17 Tukar barang (Barter trade
Page 254 and 255:
Langkah-langkah yang perlu diambil:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262:
CHAPTER 10 SCADA AND AUTOMATION SYS
Page 265 and 266:
Chapter 10 SCADA AND AUTOMATION SYS
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287:
show all

Volume 8 – Mechanical and Electrical Services - Malaysia Geoportal

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?