Volume 8 – Mechanical and Electrical Services - Malaysia Geoportal

Chapter 2 GATE DESIGN
1.0 GENERAL
This procedure briefly describes the work involved in the mechanical equipment installation.
Quality control at various stages of the installation will ensure that the installed products
will fulfill the requirement of the contractual specification.
2.0 SCOPE
The work covered by this Section shall include all labour, material, equipment, permits, and
services necessary for the execution of mechanical equipment installation and related work,
complete in accordance with the drawings and specification for the Project.
3.0 REFERENCE
[1] Design Standard BS 449, USBR Or JIS.
4.0 RESPONSIBILITIES
The Project Manager shall be responsible for the whole work. The Construction Manager and
Project Engineer shall assist Project Manager in executing the works. The Supervisor shall be
based full time at site in monitoring the works.
5.0 REFERENCE DRAWING
Relevant reference drawing
6.0 EQUIPMENTS & MACHINERIES REQUIRED
Hydraulic mobile crane, generator set, welding set, scaffolding, power tools.
7.0 MANPOWER
Trade Engineer Supervisor Foreman Fitter Welder Helper
No. 1 1 1 2 1 2
8.0 SEQUENCE OF WORKS
Receiving Equipment Delivery
a) Check all in-coming materials with corresponding delivery order and packing list to ensure
quantity and quality are in conformance.
b) Inspection of materials as per requirement of ITP
c) Store all equipment in proper manner for easy identification and issuance.
Installation Work
Tilting Gate Guide Installation
The gate guides for the tilting gates consist of:-
a) The sill beam
b) The gate side seal guide or wall plate which runs vertically.
March 2009 2A-5