ts_127007v110800p

3GPP TS 27.007 version 11.8.0 Release 11
121
ETSI TS 127 007 V11.8.0 (2013-10)
Optional.
8.27 Price per unit and currency table +CPUC
Table 87: +CPUC parameter command syntax
Command
+CPUC=,[,]
+CPUC
+CPUC=
Possible response(s)
+CME ERROR:
+CPUC: ,
+CME ERROR:
Description
Set command sets the parameters of Advice of Charge related price per unit and currency table in SIM card or in the
active application in the UICC (GSM or USIM) file EF PUCT . PUCT information can be used to convert the home units
(as used in +CAOC, +CACM and +CAMM) into currency units. SIM PIN2 is usually required to set the parameters. If
setting fails in an MT error, +CME ERROR: is returned. Refer subclause 9.2 for values.
Read command returns the current parameters of PUCT.
Defined values
: string type; three-character currency code (e.g. "GBP", "DEM"); character set as specified by
command Select TE Character Set +CSCS
: string type; price per unit; dot is used as a decimal separator (e.g. "2.66")
: string type; SIM PIN2
Implementation
Optional.
8.28 Call meter maximum event +CCWE
Table 88: +CCWE parameter command syntax
Command
+CCWE=[]
+CCWE
+CCWE=
Possible response(s)
+CME ERROR:
+CCWE:
+CME ERROR:
+CCWE: (list of supported s)
+CME ERROR:
Description
Shortly before the ACM (Accumulated Call Meter) maximum value is reached, an unsolicited result code +CCWV will
be sent, if enabled by this command. The warning is issued approximately when 30 seconds call time remains. It is also
issued when starting a call if less than 30 s call time remains. If setting fails in an MT error, +CME ERROR:
is returned. Refer subclause 9.2 for values.
Read command returns the current setting.
Test command returns supported settings.
ETSI