ts_127007v110800p

3GPP TS 27.007 version 11.8.0 Release 11
53
ETSI TS 127 007 V11.8.0 (2013-10)
0 asynchronous modem
1 synchronous modem
2 PAD Access (asynchronous)
3 Packet Access (synchronous)
4 voice
5 fax
all other values below 128 are reserved by the present document
: integer type (information transfer capability)
0 3,1 kHz
1 UDI
Implementation
Optional.
7.2 Network registration +CREG
Table 35: +CREG parameter command syntax
Command
+CREG=[]
+CREG
+CREG=
Possible response(s)
+CME ERROR:
+CREG: ,[,[],[],[]
[,,]]
+CREG: (list of supported s)
Description
Set command controls the presentation of an unsolicited result code +CREG: when =1 and there is a
change in the MT"s circuit mode network registration status in GERAN/UTRAN/E-UTRAN, or unsolicited result code
+CREG: [,[],[],[]] when =2 and there is a change of the network cell in
GERAN/UTRAN/E-UTRAN. The parameters , and are sent only if available. The value =3
further extends the unsolicited result code with [,,], when available, when the
value of changes.
NOTE 1: If the MT also supports GPRS services and/or EPS services, the +CGREG command and +CGREG: result
codes and/or the +CEREG command and +CEREG: result codes apply to the registration status and
location information for those services.
Read command returns the status of result code presentation and an integer which shows whether the network
has currently indicated the registration of the MT. Location information elements , and , if
available, are returned only when =2 and MT is registered in the network. The parameters
[,,], if available, are returned when =3. Refer subclause 9.2 for possible
values.
Test command returns values supported as a compound value.
Defined values
: integer type
0 disable network registration unsolicited result code
1 enable network registration unsolicited result code +CREG:
ETSI