ts_127007v110800p

3GPP TS 27.007 version 11.8.0 Release 11
168
ETSI TS 127 007 V11.8.0 (2013-10)
+CBCAP=
+CBCAP: (list of supported s),(list of supported
s)
Description
Set command enables reporting upon change in battery capacity level, with unsolicited result code +CBCAP: .
Consecutive reports never show same value of .
Read command returns the status of result code presentation and the current battery capacity level.
Test command returns values supported as compound values.
Defined values
: integer type. Enables and disables reporting of changes in the battery capacity level.
0 Disable reporting
1 Enable reporting
: integer type. Sets the reporting interval of the battery capacity level.
1...100 Amount that the remaining battery capacity must change before reporting).
: integer type. Gives the remaining relative battery capacity level (in percentages).
0 The battery is exhausted or ME does not have a battery connected
1...100 remaining battery capacity level (in percentages). The provided values are dependant on the
parameter . A value of 5 for parameter , means
that the following values of are appliccable: 0, 5, 10, 15, … , 90, 95, 100.
NOTE:
100% capacity is always reported, even if is set to a value where no integer
multiple equals 100.
Implementation
Optional.
8.60 Battery connection status +CBCON
Table 8.60-1: +CBCON parameter command syntax
Command
+CBCON=[]
+CBCON
+CBCON=
Possible response(s)
+CBCON: ,
+CBCON: (list of supported s)
Description
Set command enables reporting upon change in battery connection status, with unsolicited result code
+CBCON: .
Read command returns the status of result code presentation and the current battery status.
Test command returns values supported as compound values.
Defined values
: integer type. Enables and disables reporting of changes in the battery connection status.
0 disable reporting
ETSI