ts_127007v110800p

Recommendations

Info

3GPP TS 27.007 version 11.8.0 Release 11 231 ETSI TS 127 007 V11.8.0 (2013-10) 2 not registered, but MT is currently trying to attach or searching an operator to register to 3 registration denied 4 unknown (e.g. out of GERAN/UTRAN coverage) 5 registered, roaming 6 registered for "SMS only", home network (not applicable) 7 registered for "SMS only", roaming (not applicable) 8 attached for emergency bearer services only (see NOTE 2) (applicable only when indicates 2,4,5,6) 9 registered for "CSFB not preferred", home network (not applicable) 10 registered for "CSFB not preferred", roaming (not applicable) NOTE 2: 3GPP TS 24.008 [8] and 3GPP TS 24.301 [83] specify the condition when the MS is considered as attached for emergency bearer services. : string type; two byte location area code in hexadecimal format (e.g. "00C3" equals 195 in decimal) : string type; four byte GERAN/UTRAN cell ID in hexadecimal format : integer type; indicates the access technology of the serving cell 0 GSM 1 GSM Compact 2 UTRAN 3 GSM w/EGPRS (see NOTE 3) 4 UTRAN w/HSDPA (see NOTE 4) 5 UTRAN w/HSUPA (see NOTE 4) 6 UTRAN w/HSDPA and HSUPA (see NOTE 4) 7 E-UTRAN (not applicable) NOTE 3: 3GPP TS 44.060 [71] specifies the System Information messages which give the information about whether the serving cell supports EGPRS. NOTE 4: 3GPP TS 25.331 [74] specifies the System Information blocks which give the information about whether the serving cell supports HSDPA or HSUPA. : string type; one byte routing area code in hexadecimal format : integer type; indicates the type of . 0 Indicates that contains a GMM cause value, see 3GPP TS 24.008 [8] Annex G. 1 Indicates that contains a manufacturer-specific cause. : integer type; contains the cause of the failed registration. The value is of type as defined by . Implementation Optional. ETSI
3GPP TS 27.007 version 11.8.0 Release 11 232 ETSI TS 127 007 V11.8.0 (2013-10) 10.1.21 Select service for MO SMS messages +CGSMS Table 129: +CGSMS parameter command syntax Command +CGSMS=[] +CGSMS +CGSMS= +CGSMS: Possible Response(s) +CGSMS: (list of currently available s) Description The set command is used to specify the service or service preference that the MT will use to send MO SMS messages. The read command returns the currently selected service or service preference. The test command is used for requesting information on the currently available services and service preferences. Defined Values : integer type; indicates the service or service preference to be used 0 Packet Domain 1 circuit switched 2 Packet Domain preferred (use circuit switched if GPRS not available) 3 circuit switched preferred (use Packet Domain if circuit switched not available) Implementation Optional. 10.1.22 EPS network registration status +CEREG Table 10.1.22-1: +CEREG parameter command syntax Command +CEREG=[] +CEREG +CEREG= Possible response(s) +CME ERROR: +CEREG: ,[,[],[],[[, ,]]] +CEREG: (list of supported s) Description The set command controls the presentation of an unsolicited result code +CEREG: when =1 and there is a change in the MT's EPS network registration status in E-UTRAN, or unsolicited result code +CEREG: [,[],[],[]] when =2 and there is a change of the network cell in E- UTRAN. The parameters , and are sent only if available.The value =3 further extends the unsolicited result code with [,,], when available, when the value of changes. Refer subclause 9.2 for possible values. NOTE 1: If the EPS MT in GERAN/UTRAN/E-UTRAN also supports circuit mode services and/or GPRS services, the +CREG command and +CREG: result codes and/or the +CGREG command and +CGREG: result codes apply to the registration status and location information for those services. The read command returns the status of result code presentation and an integer which shows whether the network has currently indicated the registration of the MT. Location information elements , and , ETSI
Page 1 and 2:
ETSI TS 127 007 V11.8.0 (2013-10) T
Page 3 and 4:
3GPP TS 27.007 version 11.8.0 Relea
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182: 3GPP TS 27.007 version 11.8.0 Relea
Page 231: 3GPP TS 27.007 version 11.8.0 Relea
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

ts_127007v110800p

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?