ts_127007v110800p

3GPP TS 27.007 version 11.8.0 Release 11
83
ETSI TS 127 007 V11.8.0 (2013-10)
Test command returns the list of supported unsolicited result codes.
Defined values
: integer type
0 disable preferred network indication unsolicited result code.
1 enable preferred network indication unsolicited result code +CPNSTAT: .
: integer type; preferred network indication status.
0 Requested network not available.
1 GERAN/UTRAN/E-UTRAN used.
2 GAN used.
Implementation
Optional.
7.29 Current packet switched bearer +CPSB
Table 59C: +CPSB parameter command syntax
Command
+CPSB=[]
+CPSB
Possible response(s)
+CME ERROR:
+CPSB: [,,]
[+CPSB: ,,
[...]]
+CPSB=
+CME ERROR:
+CPSB: (list of supported s)
Description
Set command controls the presentation of an unsolicited result code +CPSB: , when
=1 and the corresponds to a PDP context in the PDP-ACTIVE state or to an EPS bearer context and there is
a change in the current bearer due to the reception of a control or signalling message from the network as specified in
3GPP TS 44.060 [71], 3GPP TS 25.331 [74] or 3GPP TS 36.331 [86].
Read command returns the current status of unsolicited result code presentation . The parameters and
are returned for each defined context when =1 for s that correspond to a PDP context in
the PDP-ACTIVE state or to an EPS bearer context.
Test command returns the list of supported s.
Defined values
: integer type
0 disable the presentation of the unsolicited result code
1 enable the presentation of the unsolicited result code
+CPSB: ,
: A numeric parameter which specifies a particular PDP context or EPS bearer context definition. The
parameter is local to the TE-MT interface and identifies only those PDP or EPS bearer contexts which
have been setup via AT command (see the +CGDCONT and +CGDSCONT commands).
ETSI