ts_127007v110800p

Recommendations

Info

3GPP TS 27.007 version 11.8.0 Release 11 171 ETSI TS 127 007 V11.8.0 (2013-10) 0 Both IP Address and subnet mask are stated explicitly, separated by a space. Example: "2001:0DB8:0000:CD30:0000:0000:0000:0000 FFFF:FFFF:FFFF:FFF0:0000:0000:0000:0000" 1 The printout format is applying / (forward slash) subnet-prefix Classless Inter-Domain Routing (CIDR) notation. Example: "2001:0DB8:0000:CD30:0000:0000:0000:0000/60" : integer type, decides whether leading zeros are omitted or not. Setting does not apply if = 0. 0 Leading zeros are omitted. Example: "2001:DB8:0:CD30:0:0:0:0" 1 Leading zeros are included. Example: "2001:0DB8:0000:CD30:0000:0000:0000:0000" : integer type, decides whether 1-n instances of 16-bit zero-values are replaced by only '::'. This applies only once. Setting does not apply if = 0. 0 No zero compression. Example: "2001:DB8:0:CD30:0:0:0:0" 1 Use zero compression. Example: "2001:DB8:0:CD30::" Implementation Optional. 8.63 IMS single radio voice call continuity +CISRVCC Table 8.63-1: +CISRVCC parameter command syntax Command +CISRVCC=[] +CISRVCC +CISRVCC= Possible response(s) +CME ERROR: +CISRVCC: +CISRVCC: (list of supported s) Description SRVCC provides the ability to have a seamless handover of a voice call between the PS domain and the CS domain for calls that are anchored in IMS, when the UE is capable of transmitting/receiving on only one of those access networks (PS or CS) at a given time, see 3GPP TS 23.221 [90] subclause 7.2a, annex A.1 and annex A.2 Set command informs MT about the SRVCC Support. MT normally updates the network when changing this parameter. Refer subclause 9.2 for possible values. Read command returns the status of the MT stored SRVCC Support. Test command returns supported values. Defined values : integer type. SRVCC support status 0 The UE does not have SRVCC support 1 The UE has SRVCC support ETSI
3GPP TS 27.007 version 11.8.0 Release 11 172 ETSI TS 127 007 V11.8.0 (2013-10) Implementation Optional. 8.64 IMS network reporting +CIREP Table 8.64-1: +CIREP parameter command syntax Command +CIREP=[] +CIREP +CIREP= Possible response(s) +CIREP: , +CIREP: (list of supported s) Description Set command enables or disables reporting of PS to CS Single Radio Voice Call Continuity (SRVCC), PS to CS Single Radio Video Call Continuity (vSRVCC) handover information and CS to PS Single Radio Voice Call Continuity (see 3GPP TS 24.237 [91]) and of IMS Voice Over PS sessions (IMSVOPS) indicator information, by the following unsolicited result codes: +CIREPI: IMS Voice Over PS sessions (IMSVOPS) supported indication from the network. +CIREPH: Provides PS to CS SRVCC, PS to CS vSRVCC and CS to PS SRVCC handover information. Read command returns the status of result code presentation and the IMSVOPS supported indication. Test command returns supported values. Defined values : integer type. Enables or disables reporting of changes in the IMSVOPS supported indication received from the network and reporting of PS to CS SRVCC, PS to CS vSRVCC and CS to PS SRVCC handover information. 0 Disable reporting 1 Enable reporting : integer type. Gives the last IMS Voice Over PS sessions (IMSVOPS) supported indication received from network. 0 IMSVOPS support indication is not received from network, or is negative. 1 IMSVOPS support indication as received from network is positive. : integer type. PS to CS SRVCC, PS to CS vSRVCC and CS to PS SRVCC handover information. 0 PS to CS SRVCC handover has started in the CS domain ("Handover Command" indicating PS to CS SRVCC received). 1 PS to CS SRVCC handover successful ("Handover Complete" sent). 2 PS to CS SRVCC or PS to CS vSRVCC handover cancelled ("Handover Failure" sent). 3 PS to CS SRVCC or PS to CS vSRVCC handover, general non-specific failure. 4 PS to CS vSRVCC handover has started in the CS domain ("Handover Command" indicating vSRVCC received). 5 PS to CS vSRVCC handover successful ("Handover Complete" sent). 6 CS to PS SRVCC handover has started in the PS domain ("Handover Command" indicating CS to PS SRVCC received). ETSI
Page 1 and 2:
ETSI TS 127 007 V11.8.0 (2013-10) T
Page 3 and 4:
3GPP TS 27.007 version 11.8.0 Relea
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122: 3GPP TS 27.007 version 11.8.0 Relea
Page 171: 3GPP TS 27.007 version 11.8.0 Relea
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

ts_127007v110800p

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?